P2M TOYOTA SIENNA 2010-2017 BLACK SERIES ENGINE HOOD DAMPER
* Some cutting to the under hood weather strip on the left and right fender side is needed (shorter) to make room for the hood damper body in order for the hood to close properly
* Picture car shown also cut the plastic tray area to make sure the hood damper body sits deeper down into the engine bay when hood is closed, by cutting this plastic tray area the hood will be closed and be flushed with the fenders. Without cutting the plastic tray the hood can be closed but some minor slight gap may be visible when viewing from the side of the car although it's not very noticeable
NOTE:
When installing please make sure to install the bracket labeled L and R in the right configuration:
L - LEFT DRIVER SIDE (LHD - USDM VEHICLE)
R - RIGHT PASSENGER SIDE (LHD - USDM VEHICLE)
